Warning:Make sure you scan the downloaded attachment with updated antivirus tools before opening them. They may contain viruses. Use online scannershereandhereto upload downloaded attachment to check for safety.
Posted: Sun Oct 19, 2003 6:30 amPost subject: Effetive Length
Many times for architectural reasons the compression members cross section needs to be varied uniformly over the height or length.
Is there a general formula which can be used to find out the effective length or the slenderness ratio of such members in which the compression member is say round tubular section with diameter d1 at one end which increases to diameter d2 at centre and then reduces to diameter d3 at the other end.
Youcannotpost new topics in this forum Youcannotreply to topics in this forum Youcannotedit your posts in this forum Youcannotdelete your posts in this forum Youcannotvote in polls in this forum Youcanattach files in this forum Youcandownload files in this forum
Subscriptions
FAQ
Search
Memberlist
Usergroups
Register
Donate
Profile
Log in to check your private messages
Log in to website
